Caring tips
Please read the following security information so you can know how to use the transceiver safely.
1. Please keep the radio and accessories in where the children can’t touch them.
2. Please do not disassembly radio, it will cause radio broken when non professional staff handle it.
3. Please use the standard battery and charger, avoid to damage the radio.
4. Please use the matching antenna, avoid to shorten the communication distance.
5. Do not keep the radio under the sunshine with long time, or keep it into the superheat place.
6. Do not keep the radio into where is full with the dust and damp.
7. Do not use strong chemical products, cleaning agents or strong Lotion to cleaning the radio.
8. Please don’t transmitting without installing it’s antenna.
9. If it find that radio have the peculiar smell or smoke, please turn off the supply power of radio promptly, and
contact with supplier about this case.
10. Please don’t connect the battery terminal or put the battery in the fire.
Notice
All above mention advise are applied to your radio and it’s accessories, if they still can’t working normally, please promptly contact
with supplier about this case.
If using those parts and accessories those are not producing and not selling by our company, we can’t promise that the safety and
operation of radio.
01 02
Using instructions
1. Install/Remove battery pack
Install：Please put the battery pack align with radio backside, then push it with up towards direction, until release
plus of radio base is locked.
Removing the battery pack, push it with down towards direction, until release plus of radio base unlocked.
2. Charge steps
The charger plug into the mains of 220V or 110V power outlet, the charger indicator green light flashing, the
battery pack or the radio with battery pack insert into the charger card slot.
The charger red light flashing to start charging. Charging then the charger green light flashing, charging end.
3. Install Antenna
Install the antenna into the radio connector, holding the antenna base and turning it clockwise until secure.
4. Install/Remove belt clip
If necessary install the belt clip at the rear of the battery compartment cover.
To Next Page
Loading...
Need help?
General
