07
15. Definition function of Multi - side key
16. Caller ID display
17. Main caller ID display
18. FSK code
19. All Calls, Group Calls and Selective Calls
20. SOS function
21. Priority Scan Function
22. Remote emergency alarm
23. Wide/Narrow bandwidth Selection (12.5KHZ/25KHZ)
24.SingleTone Pulse Frequency: 2100Hz/1750Hz/1000Hz/1450Hz (signaling for activating repeater)
25. Reverse Frequency
26. Stopwatch function
08
2. Variety working modes of the radio
(1) Working models.
(2)
Cross section directional transfer mode of work or dual transit work mode, the same frequency dual transfer function.
Note: the working mode is set by RPT key.
（一）
Walkie talkie display LCD screen is divided into A, B two zones, respectively, to display the working information
of the two channels. The top right of the main channel will show [MAIN], this symbol is very important, all of the
following operations and instructions for the symbol of the channel, there is no symbol of the channel, we call it the
sub frequency.
（二）
The parameters of the two working channels of the interphone can be respectively set, and when the channel
set to be set is set as the main frequency, the setting is set up.
（三）
Work in the cross directional radio relay, cross section, two-way transit mode, some functions will prohibit the
placement with walkie talkie.
3 Basic operation
1. Quick search function
Press [UP] or [DOWN] to set function or parameter, Long press [UP] or [DOWN] to quick search function.
2. DTMF
3. Reverse frequency function
When using this function TX and RX frequency will be exchanged, with CTCSS /DCS code will be exchanged; the
Operating : Under of standby states, press [*SCAN] to open this function, then press [*SCAN] again to turn off.
To Next Page
Loading...
Need help?
General
