12
Copyright 2015 RetroBelt USA, LLC
You may need to remove the seats to get to the oor pan to install
your nal anchor mounts. Install the last anchor mounts in the same
way as you did in the previous steps, then mount the seatbelts
and run them through the crack between the backrest and
bottom of the seat (See Figure 9). Reinstall the package tray, and
route the seatbelt from the retractor through the crack between
the package tray and the back seat. Check to ensure proper
operation. Make sure the retractor is not obstructed in any way.
INSTALLATION GUIDELINES
Figure 9
To Next Page
Loading...