RetroBelt Tri Five - Back Seats

11
Back Seat Installation
Use a rear RetroBelt
®
system for the back seats. You will need to
install anchor mounts behind the back seat. To do this, rst remove
the package tray, then nd a good spot on the oor pan or frame
to install your anchor point. Make a template by using a felt-tipped
marker like you did in the previous steps. Check under the car and
make sure you won’t drill into the gas tank, fuel lines, exhaust pipes,
etc. Once you’ve measured your templates and ensured that
everything lines up, drill your holes and install the anchor mounts
beneath the oor pan (See Figure 8). Now install the retractor to
the anchor mount.
INSTALLATION GUIDELINES
Figure 8
Back seat Back seat
Area behind back seat
Floor pan
Retractor
Anchor mount