20
c Make sure REVITIVE is switched off. If the control
panel is still illuminated, press the power button and
turn REVITIVE off.
d Attach the ends of the body pads to the body pad
cords. If you are using both pairs of body pads, repeat
this step for the remaining body pads.
Press connectors until no gap is between them.
Leaving a gap may cause discomfort.
e Plug the other end of the body pad cord into either of
the openings on the side of REVITIVE.
If you are using both pairs of body pads, repeat this
step for the remaining body pad cord.
f First time use only: remove the plastic liner from the
body pads, by peeling it off carefully, then discard.
Instructions for use
1718_IFU01_7244012.indd 20 27/03/2015 10:04
To Next Page
Loading...