Why are my legs aching after using Revitive Fitness Equipment?
Legs may ache after Revitive treatment if the intensity is too high, overworking your muscles. Allow muscles to recover after each session, similar to post-exercise recovery. Begin your next session at a lower, comfortable intensity and reduce the duration until your muscles adjust to the stimulation.
How to fix Revitive Fitness Equipment with no power?
If your Revitive device has no power or lights when switched on, check that the power adaptor is properly plugged into both the electrical socket and the device. Also, verify that the electrical socket is switched on. If the issue persists, contact your authorized dealer.
What to do if Revitive Fitness Equipment is on but I feel no stimulation?
If your Revitive device is on but you don't feel any electrical stimulation through the foot-pads, consider the following: * Ensure both bare feet are placed on the foot-pads simultaneously. Increase the intensity up to 50 until you feel the stimulation. * Moisturize the soles of your feet to improve conductivity. * Drink plenty of water to stay hydrated, as water conducts electricity. * Increase the intensity level gradually until you feel the stimulation. * Disconnect the Body Pad cord. * Test the device by placing one hand across both footpads and increase the intensity level until you feel the stimulation. If you still don't feel anything at intensity 50, contact your authorized dealer.
Details the intended medical uses and benefits of the REVITIVE device.
Explains the mechanism of action using Electrical Muscle Stimulation (EMS).
Lists specific conditions or situations where REVITIVE should not be used.
Provides critical warnings regarding medical conditions, implants, and usage precautions.
Offers advice on careful usage, potential skin reactions, and specific conditions.
Outlines essential safety measures, including correct usage and avoiding hazards.
Advises on what to do if negative reactions occur during or after use.
Recommends daily usage duration and frequency to avoid muscle fatigue.
Details the initial setup steps, including unpacking and connecting components.
Explains how to correctly position feet on the device and start a session.
Describes how to apply and use the electrode body pads for targeted stimulation.
Provides instructions on how to clean and properly store the device and accessories.
General| Brand | Revitive |
|---|---|
| Model | RLV |
| Category | Personal Care Products |
| Language | English |
To Next Page
