Revox SRC-2000

Troubleshooting
Ifyou have trouble configuring
or operating
the
you
have inserted the batteries
conectly
(page
below.
Appendix
B
SRC-2000, first check that
8). Then
check the items
Symptom
The
SRC-2000
doesn't operate
your
device.
You cannot operate a
device even after
configuring
the
device
using the learning
function
(page
23).
You see
an
"erro/'
display during the
learning
procedure.
You
see an
"error"
display during opera-
tion.
The LCD screen
turns off
Remedy
Move closer
to the
device. The maximum
operating
distance
is
approximately 10 me-
ters.
Ensure
that
you
are
aiming
the SRC-2000
directly
at the device and that there are no
obstructions between the SRC-2000 and the
device.
Ensure
that
you
have used the learning
function
(page
23) to configure the device.
Make
sure that the desired device on the
sRc-2000 LcD has been selected.
Make
sure that
you
have
correctly
"mapped"
your
device's remote control
to the SRC-
2000.
Glear the device data
from
the SRC-2000
(page
27)
and carry
out
the
learning
func-
tion aoain
.
Try
the
learning
procedure
again
(page
23).
The
button that
you
pressed
has not
been
configured. Configure the button using
the
The SRC-2000 is
preset
at the factory
to
automatically switch the LCD
off after
25
minutes if left
unused. Just
press
the
Hardware Access Button
(9
to turn the
SRC-2000
back on