3) Press & hold the Store button until the LED flashes.
Now every time you switch to that channel or Aggression setting, the Virtual Cabinet you have
saved will be loaded by the embedded Two notes Torpedo regardless of the position of the
Virtual Cabinet rotary switch.
Disabling Virtual Cabinet Saving
To disable this recall system & have all channels default to the Virtual Cabinet’s rotary switch
position (outside of any MIDI commands):
1) Press & Hold the Aggression button, then power on the amplifier.
2) If the Aggression LED flashes blue, the Virtual Cabinet Saving option is disabled. If the
Aggression LED flashes RED, the cab save feature is enabled.
Amp Startup Settings
By default, G20 will power up with Channel 1 loaded & all options turned off. However, any
combination of channels, Aggression settings & functions can be saved so that the amplifier will
always power up with your favorite settings.
In order to perform this:
1) Set the G20 how you would like it to power up.
2) Press the store button.
3) The Store LED will now flash
4) Press the Channel button. The Store LED will quickly flash on & off.
Your preferred setting will now be loaded when the amplifier is powered up, until changed.
To Next Page
Loading...
