CC Commands
In order to use CC commands, the Generator functions have all been given a designated
number & on or off setting. When using & selecting a function the number associated with the
function must be used & then the setting of the function (on or off) must also be sent. Most MIDI
equipment (pedals etc) allows you to select a CC number & then designate whether it be turned
on or off. (Consult the external equipments’ instruction manual). The following commands &
their CC numbers need only be sent an on command (0-63) as they are used to switch between
channels & Aggression levels which cannot be turned off, only changed to a different channel or
level, on & off commands sent will produce the same result.
Function + CC Number (Hex Value)
● Channel 1 - 16 - (0x10)
● Channel 2 low Aggression - 18 - (0x12)
● Channel 2 medium Aggression - 19 - (0x13)
● Channel 2 high Aggression 20 - (0x14)
The following command will switch to Channel 2 & then toggle through the Aggression levels
with each use of the command.This command will also respond to an on & off command with
the same result:
● Channel 2 plus Aggression toggle: 24 – (0x18)
The following commands control functions that are turned on & off. These functions require an
off (0-63) & on (64-127) command (byte) to be sent with the CC number to either turn them on
or off. If you are trying to use them & are not getting them to respond, chances are you are
sending the wrong command byte ( 0-63 is OFF & 64-127 is ON). (Consult the peripheral’s
instruction manual)
● Two notes Reverb: 26 – (0x1A)
● 4W/20W: 27 – (0x1B)
● Wide: 28 – (0x1C)
● Pre/Post: 29 – (0x1D)
To Previous Page
Loading...
