• Always clean the probe accordingly before and after each use (See Care and
Cleaning).
• It is recommended that you measure the temperature 3 times in the same ear.
If the 3 measurements are different, select the highest one. (Allow 30 seconds
between each measurement).
• Before measurements, remain in a stable environment and avoid exercise and
bathing for 30 minutes.
5. DIRECTIONS FOR USE - FOREHEAD MODE
1. If probe is not attached, attach following the steps below:
Attaching Forehead Probe: underneath the measuring probe you will see a
small silver button. When attaching the forehead probe line up the silver
button with the extended plastic piece on the inside of the forehead probe.
2. Press the ON/OFF button.The last measurement reading will automatically be
shown on the display for 2 seconds with the “M” icon.
3. When the “
” icon is displayed on the screen and a beep sound is heard, the
thermometer is ready for measurement.
4. Place the probe gently onto the area approximately 1 cm above the center of
the eyebrow. If the eyebrow area is covered with hair, sweat or dirt, please
remove the obstacle beforehand to improve the reading accuracy.
To Next Page
Loading...
