9
• Rexener water heater, including installed fuel supply hose and power connections to the
circulation pump control and circulation pump heater control.
• Fuel tank with a fuel level gauge in the cap and a quick coupling for the tank’s outgoing fuel
hose.
• Connections of the Rexener water heater’s metal connections for a 50 mm water hose (2 pcs).
• Plugs for the Rexener water heater’s water circuit (2 pcs).
• Sealing tape for the threads of the water circuit connection (1 roll).
• Water heating circuit draining valve.
• Fuel hose connector and securing hose clamp.
• Chimney pipe (1 pcs) and cap (1 pcs)
• The manufacturer and importer strongly recommend ordering the installation service for
the Rexener water heater.
• Place the Rexener water heater in the position reserved for it. Ensure that the heater is in the
appropriate and stable position horizontally and vertically by using the adjustable legs.
• Screw in the pipe connections suitable for the heater’s water connections. Wind sealing tape
around the threaded section of the pipe connections in the direction of the thread.
• Plug the water connections on the other side of the heater. Wind sealing tape around the
threaded section of the plugs in the direction of the thread.
• Install the heating element drain valve included in the delivery in the lower section of the water
heating element Use sealing tape.
• Ensure the suitability of the hose connections of the water basin. Install any reducers that may
be needed.
• Position the circulation pump in a suitable location between the water basin to be heated and
the Rexener heater. Install the circulation pump in connection to the lower water hose.
• Shorten the water hoses to the appropriate length and install them. Remember to install the
hose clamps but do not tighten them.
• Dimension the upper water lower and install it.
• Screw the water hose clamps closed.
• Attach the connector of the circulation pump’s control cable to the water heater.
• Thread the fuel supply hose through the designated hole at the bottom of the housing.
• Attach the fuel supply hose connector to the end of the hose. Tighten the hose clamp.
• Install the fuel tank on the base you have reserved for it.
• Connect the fuel hose connector to the fuel tank connector.
• Fill the fuel tank. The manufacturer and importer recommend using biodiesel. Light fuel oil and
regular diesel are also suitable fuels.
• Connect the Rexener water heater’s power plug to the power socket.
• You can now begin to run water into the tub or pool to be heated.
Content of the Rexener water heater delivery
Installing the Rexener water heater
To Next Page
Loading...