With the use of the smart hardwire kit (sold separately). After the car engine is
turned off, the smart hardwire kit detects the power loss and sends a command
to the host device. The system enters a standby state. The mini USB plug must
always be kept connected to the USB port of the device so as to ensure a
constant power supply to the smart hardwire kit.
In parking mode, the dash cam will turn on, record a 15s video, lock the video,
and then turn off again. When a recording is started, the screen does not light up
and there is no booting sound.
1.
2.
• Rear Camera Mirroring (On, Off):
This feature displays a reverse image on-screen display for rear camera view.
On enables mirroring display and off displays the original image.
• Mute Video Recording (On, Off):
When mute is on, video is recorded with no audio. This function can be directly
switched on by clicking the icon on the video recording interface.
• Parking Monitor (On, Off):
The characteristics and precautions of the parking monitor are as
the follows:
This feature is on when you see the illuminated icon in the status bar on the
video recording interface, and it is off when you see the grayed-out icon.
When the parking monitor is activated, its standby state will be activated after the
engine is turned off. When the car is shocked by an external force and the sensor
detects the impact, the system will begin video recording (Intelligent hardwire kit
required).
• Time Stamp:
Off, On
25
To Next Page
Loading...
