Due to excessive mishandling, this device could be damaged during
transportation. To avoid the high cost of troubleshooting and repairs due to
repeated mounting and removal, we recommend that you assemble all
components first after delivery and test the device with the on-board charger
power supply. Make sure that the device is visibly undamaged prior to installation.
Contact our Customer Care with any questions or concerns.
I. Install the Device
Turn off the engine of the car.
Place the MicroSD card into the slot.
Secure the dashcam to the rearview mirror of the car.
Plug the GPS module into the GPS port and secure the module to a pillar on the
inside of your vehicle that is near the reveiw mirror. The antenna receiver side (the
side without 3M adhesive) faces the outside and the side with 3M adhesive faces
down. It should be properly secured.
Plug the charger into the car’s cigarette lighter and connect it to the dash cam’s
Type-C Port.
Installation
!
2.
3.
The optional rearview camera is mounted on the rear of the car. Pay attention to its
orientation during installation. Plug the rearview camera connector into the
corresponding port of the dashcam once the installation is completed. Adjust the
position of the lens to ensure that it aligns horizontal with the ground. Start the
engine to check the video functionality of the device.
4.
5.
Note:
1.
8
To Next Page
Loading...
