RF 812N - Machine Transportation and Installation; INSTALLATION PROCEDURES

4. TRANSPORTATION OF MACHINE:
Unpacking
1. Transportation to desired location before unpacking, please use lifting jack.
(Fig. B)
2. Transportation after unpacking, please use heavy-duty fiber belt to lift up the
machine.
Fig. B
ALLWAYS KEEP PROPER FOOTING & BALANCE WHILE MOVING THIS MACHINE.
5, Installation:
As this machine weights 125 kg. It is recommended that the machine shall be transported, with help of lifting jack.
Transportation Recommendation:
(1). Tighten all locks before operation.
(2). ALWAYS Keep proper footing & balance while moving this 125kgs machine,
and only use heavy duty fiber belt to lift the machine as Fig. A
(3). TURN OFF the power before wiring, & be sure machine in proper grounding,
Overload & circuit breaker is recommended for safety wiring.
(4). CHECK carefully if the saw blade is running in
counter-clockwise direction if not , reverse the
wiring per circuit diagram then repeat the running test.
As this machine weights 130 kg. It is recommended that the machine shall be
transported, with help of lifting jack.
Transportation Recommendation:
(1). Tighten all locks before operation.
(2). TURN OFF the power before wiring, & be sure machine in proper grounding,
Overload & circuit breaker is recommended for safety wiring.
(3). CHECK carefully if the saw blade is running in
counter-clockwise direction if not , reverse the
wiring per circuit diagram then repeat the running test.
(4). KEEP machine always out from sun, dust, wet, raining area.
Installation steps for plastic belt cover:
A), Open plastic molded belt cover. Inlay the left indentation to the bottom of the pulley, if the gap is too small. Loose the
fixing screws of pulley. Then, move the pulley out slightly, it will be very easy to set in.
B). Turn the belt cover with the direction of counterclockwise, which enable the indentation set into
the pulley, if the gap is too small. Loose the fixing screws of pulley. And move the pulley out slightly, then, it will be
easy to set in.
C). Inlay the left indentation completely to the pulley. Adjust the pulley at the same level surface, then, fix all related
screws.
-4-