RFI G-router - Ethernet and PoE Pin Assignments; RS-232 Pin Assignments

The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V.
QIG_G-router_1.2.2 Page: 7(21)
2.1 Ethernet and 802.3af (Power over Ethernet) Pin Assignments
2.2 RS-232 Pin Assignments
The following signals are internally connected in the RS-232 port on the G-router unit:
• Carrier Detect (pin 1), Data Terminal Ready (pin 4) and Data Set Ready (pin 6)
• Request to Send (pin 7) and Clear to Send (pin 8)