The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V.
Page: 8(21)
2.3 Relay connections
The G-router has a low power relay contact that can be used for remote controlling low power
devices. In order to connect the relay contact to the low power device you can use a cable with
an RJ-11 connector. The two middle pins (pin 3 and 4) of the RJ-11 connector are connected to
the relay, whereby the relay is normally open. This contact is closed as soon as the relay is
activated. Pins 2 and 5 of the RJ-11 connector are connected to the relay in a normally closed
configuration. When the relay is activated this contact opens.
Please note: This relay is specified for low power devices only. This means that the
maximum ratings are 100V @ 500mA for switching purposes maximum. In case you want to
switch higher voltages and/or higher currents you need to use an external relay, such as RFI
Engineering’s single port remote power switch; RE.99.R1NC.
To Next Page
Loading...