The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V.
QIG_G-router_1.2.2 Page: 9(21)
3 Installation Overview
The G-router is a radio device capable of transmitting and receiving in the
850/900/1800/1900MHz bands. Because the G-router unit operates in the radio frequency bands
it can be susceptible to interference that can reduce range. Install the G-router in such a way
that adequate GSM reception is obtained. You can see the GSM signal levels in the configuration
menu of the G-router. Please see paragraph 5.4 for retrieving the GSM status.
3.1 Inserting the SIM card
In order to start using the G-router you need to insert a miniature SIM card. Please make sure
the SIM card is a data card and the mobile network operator supports CSD. The SIM
card holder is located inside to the G-router and can only be accessed by unscrewing the four
screws in the bottom of the unit. To insert a SIM card take the following steps:
1. Make sure the G-router is switched off, by unplugging the power supply.
2. Unscrew the four screws in the bottom of the unit.
3. Turn the unit over and carefully lift the top of the unit.
4. The SIM card holder is located on the GSM main board.
To Next Page
Loading...