To Next PageTo Next Page
Need help?Do you have a question about the Rheem 50 Gallon and is the answer not in the manual?
General| Capacity | 50 Gallons |
|---|---|
| Brand | Rheem |
| First Hour Rating | Varies by model |
| Recovery Rate | Varies by model |
| Energy Factor | Varies by model |
Manual for residential gas water heaters, FVIR certified.
Critical safety instructions and steps to take if gas is detected.
General safety guidelines and precautions for the water heater.
Details on locating and connecting the water heater.
Instructions for operating, caring for, and maintaining the water heater.
Tips for resolving issues and contacting support.
Critical safety warning about proper installation of draft hood and venting to prevent hazards.
Warning about the danger of flammable materials near the water heater.
Warning about scalding hazards from high water temperatures and setting guidance.
Instructions and precautions for detecting and responding to gas leaks.
Specific safety and bracing requirements for installations in California.
Key safety measures to follow before and during operation.
Detailed guidelines on where to install the water heater, including clearances.
Specific clearance measurements required from combustible materials.
Requirements for air supply needed for proper combustion and ventilation.
Warnings about operating the heater in corrosive environments and warranty voidance.
Explanation of thermal expansion and methods to control it.
Typical installation diagram and instructions for water connections.
Guidelines for installing the temperature and pressure relief valve.
Steps to properly fill the water heater tank before operation.
Explanation of condensation formation and potential causes.
Details on gas piping, shut-off valves, and pressure requirements.
Methods for testing gas connections for leaks.
Suitability and considerations for water heater installation at high altitudes.
Information and cautions regarding the use of external insulation blankets.
Critical instructions for installing the draft hood and venting system.
Table detailing clearance requirements for US installations.
Instructions for installing pipe insulation for energy efficiency.
How to install insulation for the Temperature & Pressure relief valve.
Information on installing factory-supplied heat traps for energy efficiency.
Recommended actions during water heater installation.
Actions to avoid during water heater installation.
Checklist for water heater location, water supply, and gas supply.
Checklist for relief valve installation and venting system.
Instructions for dual-purpose heating applications.
Diagram illustrating typical piping for combination heating systems.
Critical safety warnings to read before attempting to operate the water heater.
Step-by-step procedure for lighting the water heater's pilot and main burner.
Essential safety measures to follow during water heater operation.
Guide to adjusting water temperature for safety and efficiency.
Detailed explanation of temperature settings and potential issues like stacking.
Step-by-step instructions for draining the water heater tank.
Recommended maintenance tasks for long-term reliability.
Tips for maintaining proper clearances and ventilation.
How to inspect the gas venting system and chimney for proper function.
Procedures for inspecting the pilot and main burners.
Information on the anode rod's function and maintenance.
Guide to common problems and their solutions.
Further common problems and solutions for the water heater.
Explanation of status light codes and their potential solutions.
How to order replacement parts for the water heater.
Information on how to contact the manufacturer for service inquiries.
