DISPLAY PANEL
22
Timer 1 Setting
• To set the Timer 1 ON setting;
◼ Press and hold the “Clock” key until the Timer ’1’ icon commences to flash. This will take 2 seconds.
The “Clock” key illuminates red.
The Timer ’ON’ icon and either “- - : - -“ or the previously set ON time in the Time / Date Display Area
illuminate.
◼ Press the “Clock” key.
“- -“ or the previously set ON hour digits for the Timer 1 setting commence to flash in the Time / Date
Display Area.
The Timer ’1’ icon changes from flashing to a solid illumination.
◼ Press the "Up" key or "Down" key to select the ON hour.
◼ Press the “Clock” key to save the ON hour.
The previously set minute digits commence to flash.
◼ Press the "Up" key or "Down" key to select the ON minutes.
The minutes change in increments of 10 minutes.
◼ Press the “Clock” key to save the ON minutes.
The Timer ’ON’ icon goes out, and the Timer ’OFF’ icon illuminates.
“- -“ or the previously set OFF hour digits for the Timer 1 setting commence to flash in the Time / Date
Display Area.
• To set the Timer 1 OFF setting;
◼ While “- -“ or the previously set OFF hour digits are flashing, press the "Up" key or "Down" key to
select the OFF hour.
◼ Press the “Clock” key to save the OFF hour.
The previously set minute digits commence to flash.
◼ Press the "Up" key or "Down" key to select the OFF minutes.
The minutes change in increments of 10 minutes.
◼ Press the “Clock” key to save the OFF minutes.
The Timer 1 period is now set.
The Timer ’2’ icon commences to flash.
The Timer ’ON’ icon and either “- - : - -“ or the previously set Timer 2 ON time in the Time / Date
Display Area illuminate.
◼ Proceed to program the Timer 2 period if this is required.
If a Timer 2 period is not required to be set or reset, then 10 seconds after the Timer 1 period having
been set, the water heater will exit Timer programming and the Display Panel will return to the main
interface, and:
The “Clock” key remains illuminated red.
The Timer ’1’, Timer ’2’ (if set), Timer ’ON’ and Timer ’OFF’ icons illuminate, and the time is
displayed in the Time / Date Display Area.
To Next Page
Loading...
