Rheem CRTGH-95X Series - Page 29

29
INSTALLATION INSTRUCTIONS
General
• Every vent or air intake pipe penetration of a floor or
ceiling should be sealed.
• Failure to install and properly vent the water heater
to the outdoors as outlined on pages 34 through 46
can result in unsafe operation.
• Long hot water lines should be insulated to conserve
water and energy.
• The water heater and water lines should be protected
from exposure to freezing temperatures.
• Minimum water heater clearances from combustible
and noncombustible construction are as follows:
– 1/2 in. (1.3 cm) for sides
– 0 in. (0 cm) for rear with support bracket(s)
– 12 in. (30 cm) from the bottom, top, and front
12" min.
(300 mm)
12" min.
(300 mm)
1/2" min.
(13 mm)
12" min.
(300 mm)
0"
(0 mm)
0" min.
(0 mm)
Sealed
• D o not install the water heater in
areas prohibited by CAN/CSA B149.1
Natural Gas and Propane Installation
Code.
• D o not install the water heater where
it is subject to vibrations.
• D o not install the water heater in a
recreational vehicle, mobile home,
boat, or other watercraft.
• D o not install the water heater near
vents for heating and cooling unless
a minimum clearance of 4 ft (1.2 m) is
maintained.
Choosing a Location (cont.)