67
INSTALLATION INSTRUCTIONS
While “120” is blinking, press the UP and DOWN
adjustment buttons at the same time. “120” will
stop blinking.
Press the UP or DOWN adjustment button to set the
desired temperature.
Turn on the gas and water to the water heater by
opening the shut-off valves.
To limit maximum water temperature setting
to 120°F (49°C):
Turn on the remote control.
Turn off the gas and water to the water heater by
closing the shut-off valves.
Press the DOWN adjustment button repeatedly
until 100°F (38°C) or 85°F (29°C) shows in the LED
display. Hold the DOWN button until the number on
the display starts to blink.
While the number is blinking, press the UP and
DOWN adjustment buttons at the same time. The
number will stop blinking.
Press the UP or DOWN adjustment button to set the
desired temperature.
Turn on the gas and water to the water heater by
opening the shut-off valves.
4
5
6
1
2
3
4
5
6
Setting the Water Temperature (cont.)
Start/Adjust
To Next Page
Loading...
