Rheem HCL Series - User Manual

ACD RHEEM MANUFACTURING CO. RESEARCH & DEVELOPMENT DEPARTMENT
R
E
V
01
REVISED FOR MISELLANEOUS TEXT REVISIONS.
Y-0699S176
8/4/2020
04
REVISED MISCELLANEOUS TEXTS.
VYM
105766
5/4/2022
02
REVISED MISCELLANEOUS TEXTS.
VYM
Y-0699S214
1/18/2021
05
REPLACED DIAGRAM ON PAGE 43, 90-106710-02 WAS -01.
MAB
112938
8/11/2023
03
ADDED SECTION 5.3.
VYM
100062
3/8/2021
STANDARD TOLERANCE UNLESS OTHERWISE NOTED: -FRACTIONAL ± 1/32 -ANGULAR +1° -3° -DECIMAL ± .030 -REFERENCE ( )
NOTE: ALL BRAKES ARE 90
°
UNLESS OTHERWISE SPECIFIED
R&D DEPARTMENT PRINTED MATERIAL
NOTE:
WHEN PRINTED MATERIAL IS RECEIVED ON THIS PART NUMBER, CHECK THAT THE REVISION IS
CORRECT AND THAT ANY SPECIAL INSTRUCTIONS LISTED BELOW WERE FOLLOWED.
THE 2D DATA MATRIX AND THE MANUFACTURER’S PART NUMBER ARE TO BE PRINTED ON I&O COVER
SHEET. SEE ADS-104669-01 FOR DATA MATRIX SPECIFICATIONS.
SPECIAL INSTRUCTIONS:
(3) 5/16” DIA. HOLES (TO FIT 3-RING BINDER) REQUIRED ALONG LEFT EDGE OF BOOKLET.
CHECKED BY:
APPROVED BY:
RELIAB. ENGR.:
VENDOR APPROVAL:
DR. BY:
DATE :
MJM
3/21/2018
ORIGINAL
RELEASE No.:
H-1032S004
INSTALLATION INSTRUCTIONS FOR
(-)HGN-H AIR HANDLERS
PART NO.
REV.
92-106595-02 05

Rheem HCL Series Specifications