Rheem IKONIC RTGH-SR84i - Setting Temperature Display; Setting Beep on Alarm

IKONIC Tankless Water Heater Service Manual
25
GENERAL INFORMATION
1.6.2 SETTING THE
TEMPERATURE DISPLAY
1.6.3 SETTING BEEP
ON ALARM
1. Press the “ SETTINGS ” button.
2. Press the “ ▼ ” or “ ▲ ” button until "Temp Display”
is displayed, and press " ENTER " button.
3. The factory setting is " Fahrenheit ". Press the “ ▼ ”
or “ ▲ ” button to select " Fahrenheit " and Celsius
", and press ENTER " to confirm. To exit this set-
ting, press BACK " button until the initial screen is
displayed.
1. Press the “ SETTINGS ” button.
2. Press “ ▼ ” or “ ▲ ” button until “ Beep On Alarm”
is displayed, and press " ENTER " button to con-
firm.
3. The Factory setting is "NO". Press the “▼” or “▲”
button to select NO " and YES ", and press "EN-
TER" to confirm. To exit this setting, press "BACK"
button until the initial screen is displayed
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Temp Display
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Fahrenheit
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Beep On Alarm
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Temp Display
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Fahrenheit
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Yes
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT