Rheem RA1760AJ2CB - Test and Fault Recall Mode Operations

34
s4HE50MODECAUSESTHE)##TODOTHEFOLLOWING
 2ESETSTHE)##FROMANYACTIVEPROTECTIONLOCKOUT
mode
 2ESETSTHEMINUTEANTISHORTCYCLETIMER
 %NERGIZESTHEUNITWITHOUTACALLFORUNITOPERATION
s)FTHEMINUTEANTISHORTCYCLETIMERORSECOND
MINIMUMRUNTIMERISACTIVEAFLASHINGhCvORh#vIS
DISPLAYEDONTHEDUALSEGMENT,%$SANDACALLFOR
unit operation is present, UP mode causes:
 !hCvTODISPLAYMOMENTARILYONTHEDUALSEGMENT
display
 4HECOMPRESSORWILLSTART
 4HEDISPLAYWILLCHANGETOASTEADYhCvORh#vTOSHOW
the current call for unit operation.
NOTE: If a call for unit operation is present at
the end of UP mode will cause the unit to continue to
operate.
s)FNOCALLFORUNITOPERATIONISPRESENT50MODECAUSES
 !STEADYhCvAPPEARSONTHEDUALSEGMENT,%$S
 4HECOMPRESSORWILLSTART
 4HECOMPRESSORWILLTURNOFFAFTERSECONDS
NOTE: Entering UP mode without a call for
unit operation will cause the compressor to run
5-seconds.
INSTALLATION
Test and Fault Recall Modes
Test and Fault Recall Modes
Fault Recall Mode (UP and Select Buttons)
s%NTERFAULT RECALL mode by pressing the UP and
Select buttons at the same time with insulated probes
FORTHREESECONDSANDRELEASE
s7HENENTERINGANDEXITING&!5,42%#!,,MODETHE
FC will be displayed.
s7HENENTERINGFAULT RECALL mode, the ICC will
automatically scroll through stored faults on the dual
7-segment LEDs.
s%ACHFAULTISDISPLAYEDONETIMEWITHTHETOPRIGHT
hand segment of the dual 7-segment display activated
between faults.
s%ACHFAULTISDISPLAYEDWITHTHEMOSTRECENTFAULT
displayed first.
s!MAXIMUMOFSIXINDIVIDUALFAULTSCANBESTORED
s!MAXIMUMOFTHREECONSECUTIVEIDENTICALFAULTSARE
stored.
s!hvWILLBEDISPLAYEDWITHNOFAULTSARESTORED
s4HE)##WILLAUTOMATICALLYEXITTHEFAULT RECALL
mode after 10 seconds. Use UP and SELECT to scan
through faults.
)-0/24!.4 The ICC stores the previous two weeks of
history faults. The complete stored fault history cannot be
displayed using a conventional thermostat.
Clear Fault History (UP and Select Buttons)
s#LEAR&!5,4()34/29BYPRESSINGBOTH4%34AND
3%,%#4BUTTONWHILEFAULTISDISPLAYEDFORlVE
seconds with insulated probes and release.
Lower case “c”