11
For iPhone 6 and Earlier Versions
1. The "Wi-Fi setup" screen will appear. Select or enter
the Wi-Fi network you want your unit to be connected
to and enter the network password. See Figure 19.
2. Press the "Continue" button.
Selec t the HOTSPOT iden�fier that matches the unit's display as shown in
Figure 19. Wi-Fi Setup
6. Raymote app will provide the Wi-Fi credentials to
your unit. This process may take a few seconds. See
Figure 17.
Figure 18.
7. Continue in page 12 to Boiler Profile setup.
3. "Check your Device" screen will appear. Ensure
Wi-Fi signal is available in the area, then press the
"Ready" button.
Figure 20. Check your Device
NOTE:
mobile app will require you grant permission to access
data. See Figure 21.
Figure 21. Grant Permission
To Next Page
Loading...