17
Main View
• The main view of Raymote display a list of the heaters
added in to your Raymote Organization.
• Each heater is represented by a tile with its name and
an overview of the heater operation parameters.
Figure 34. Main View - Heaters List
• Raymote organization list can handle 1 or multiple
Commercial and Residential Raypak heaters
equipped with Raymote.
Heater Name
• Heater name is defined during the Heater connection
and setup, but it can be changed anytime from the
heater settings.
Inlet Water Temp
• The Inlet water temperature measured by the heater is
displayed in this field. Inlet Water Temperature readings
are taken from the Inlet of the heat exchanger.
Outlet Water Temp
• The Outlet water temperature measured by the heater
is displayed in this field. Outlet Water Temperature
readings are taken from the Outlet of the heat
exchanger.
Firing Rate
• The Firing Rate indicator displays a real-time rate
provided by the Heater. The values displayed varies
with the modulation of the heater.
• The offline indicator is displayed only when the Heater
cannot be detected online.
• Offline status can be cause by a heater disconnected
from power, Wi-Fi signal weak or not available, or due
to any change in Wi-Fi signal name or password.
• Check the Connectivity Troubleshooting section for
details on how to recover or reconnect a heater to
Raymote.
To Next Page
Loading...