To Next PageTo Next PageHow to clean Rheem Furnace filter?
To maintain optimal performance of your Rheem Furnace, it's essential to keep the filter clean. Regularly vacuum any dirt from the filter, then wash it with detergent and water. Allow the filter to air dry completely before reinstalling it.
What to do if Rheem RGRK Furnace flames are distorted?
If the flames in your Rheem Furnace are distorted or show signs of back pressure, it indicates a potential blockage in the vent and inlet air system. Inspect the vent and inlet air system for any obstructions. If carbon and scale are present in the heat exchanger tubes, the entire heat exchanger assembly should be replaced.
What to do if Rheem RGRK condensate trap is blocked?
A blocked condensate trap in your Rheem Furnace can cause water to accumulate in the primary heat exchanger, leading to the overtemperature switches tripping. Check the condensate trap for any debris or blockages and ensure it is filled with water.
General| Category | Furnace |
|---|---|
| Product Series | RGRK |
| Fuel Type | Gas |
| Input BTU/h Range | 40, 000 - 120, 000 BTU/h |
| Warranty | Limited lifetime heat exchanger warranty, 10-year parts warranty |
Warnings regarding combustion product discharge and the critical role of air filters for furnace operation and safety.
Prohibits mobile home installation; mandates specific safety clearances for garage installations.
Outlines requirements for furnace operation in buildings under construction, including safety checks.
Hazards of duct leaks causing air imbalance and migration of pollutants into living spaces.
Mandates CO detectors, signage, and inspection compliance for MA installations.
Guidelines for choosing furnace location, considering ductwork, gas piping, and clearances.
Importance of proper clearances to combustibles and accessibility for maintenance and service.
Proper positioning, return air, and supply air connections for upflow furnace installations.
Ducting considerations for downflow and horizontal furnace installations, including air sealing.
Guidelines for proper venting, combustion air, and safety switches for furnace operation.
Procedures for integrating the furnace with existing vent systems, ensuring safe operation.
Requirements for combustion and ventilation air in non-direct furnace installations.
Guidelines for providing adequate combustion air in confined spaces.
Rules for installing vent pipes, including slope, support, and termination.
Specifics for elevated tee terminations to clear anticipated snow levels.
Requirements for direct vent installations, including piping and kits.
Specific requirements for direct vent combustion air supply and termination.
Connecting vent and combustion air pipes to the upflow furnace.
Connecting vent and combustion air pipes to downflow/horizontal furnaces.
Details on condensate trap location, connections, and neutralizer use for upflow models.
Warnings and requirements for natural gas supply and conversion to LP.
Guidelines for installing gas piping according to codes and standards.
Information on selecting and ordering replacement orifices for LP conversion.
Importance and wiring of isolation relays for certain thermostats.
How to connect an electronic air cleaner to the furnace control.
How to connect a humidifier to the furnace control for operation.
Details on the optional drain kit for downflow models.
Configuring twinned furnaces for single-stage thermostat operation.
Setting up twinned furnaces for two-stage operation with a two-stage thermostat.
Requirements for installing furnaces at high altitudes for natural gas.
Requirements for installing furnaces at high altitudes for LP gas.
Proper ignitor setup and operational sequences for single/two-stage thermostats.
How to adjust furnace input for natural gas, LP gas, and setting the input rate.
How to perform a temperature rise check to verify correct airflow for optimal performance.
Importance of filter maintenance and how to access and clean filters.
Details on filter sizes and where to locate them for different furnace models.
Information on motor lubrication requirements and cleaning procedures.
Advising the customer on system operation for efficiency and longevity.
Recommendations for annual inspection of furnace components for safe operation.
Reference to the complete wiring diagram for electrical troubleshooting.
