To Next PageTo Next Page
Need help?Do you have a question about the Rheem RH1T4821MTANJA and is the answer not in the manual?
General| Model | RH1T4821MTANJA |
|---|---|
| Type | Air Handler |
| Cooling Capacity | 4 tons |
| Airflow | 1600 CFM |
| Refrigerant | R-410A |
| Voltage | 208/230V |
| Phase | 1 |
| Width | 21 inches |
| Depth | 21 inches |
| Shipping Weight | 130 lbs |
Lists required tools and refrigerant specifications for R-410A systems.
Specific tools needed for R-410A installations.
Procedures for connecting refrigerant lines and charging the system.
Steps for charging the system with refrigerant.
General guidelines and code compliance for electrical wiring.
Importance and methods for proper unit grounding.
Information on power wiring requirements and installation.
Electrical data for H1P models with electric heat kits.
Electrical data for H1T models with electric heat kits.
Additional information and considerations for electric heater kits.
Introduction to airflow performance data and selection.
Table of airflow limits for various operating conditions.
Instructions for selecting the correct blower motor speed tap.
Speed selection for H1P models with PSC motors.
Speed selection for H1T models with ECM motors.
Airflow performance data tables for 240V H1P PSC motor models.
Airflow data for H1P PSC motor models across different voltages.
Airflow data for H1T ECM motor models across voltages.
A checklist to verify all installation steps before system startup.
Steps for performing a system startup and operational verification.
Methods to check and estimate indoor airflow.
Procedure for checking refrigerant charge after airflow is confirmed.
Wiring diagram for H1P models at 115V.
Wiring diagram for H1P models at 208/240V.
Wiring diagram for H1P models at 480V.
Wiring diagram for H1T models at 115V.
Wiring diagram for H1T models at 208/240V.
Wiring diagram for H1T models at 480V.
