To Next PageTo Next Page
Need help?Do you have a question about the Rheem RH1T3621MTANJA and is the answer not in the manual?
Disconnect all power before installing or servicing. Hazardous voltage can cause severe injury or death.
Ensure power is de-energized and locked before removing blower assembly to prevent electrical shock.
Installation, service, and maintenance must be performed by trained, qualified personnel.
Duct leaks can draw pollutants into living space, causing property damage, injury, or death.
Read instructions thoroughly before installation. Failure may result in injury or death.
Use a combustible floor base for downflow on combustible flooring to prevent fire.
Permanent grounding is mandatory to prevent electrical shock, injury, or death.
Do not connect return ductwork to heat-producing devices; risk of fire or explosion.
Improper installation not following UL certification or instructions can cause unsafe conditions.
CO from fuel devices can enter living space, causing severe injury or death.
Lists required tools and R-410A refrigerant specs for installation and servicing.
Procedure for leak testing the system with dry nitrogen after brazing.
Steps to evacuate the system to 500 microns or below before charging.
Procedure for charging the system after evacuation and installation completion.
The unit must be permanently grounded for safety.
Electrical ratings for electric heater kits for (-)H1P models.
Select blower motor speed based on static pressure and model type.
Checklist of essential items to verify before initial system start-up.
Procedures for performing an operational check-out after installation.
Check refrigerant charge after confirming correct airflow.
Schematic and electrical wiring diagram for (-)H1P with 115V supply.
Schematic and electrical wiring diagram for (-)H1P with 208/240V supply.
Schematic and electrical wiring diagram for (-)H1P with 480V supply.
Schematic and electrical wiring diagram for (-)H1T with 115V supply.
Schematic and electrical wiring diagram for (-)H1T with 208/240V supply.
Schematic and electrical wiring diagram for (-)H1T with 480V supply.
General| Model | RH1T3621MTANJA |
|---|---|
| Type | Air Handler |
| Airflow | 1200 CFM |
| Refrigerant | R-410A |
| Phase | 1 |
| Motor Type | PSC |
| Cooling Capacity | 36000 BTU |
| Electrical Supply | 208/230V |
