Rheem RRPL-B - Page 16

16
FIGURE 5
COVER GASKET DETAIL FOR UNITS SHIPPED FOR DOWNFLOW
APPLICATION BEING CONVERTED TO SIDE DISCHARGE
TAPE
AROUND FLANGE
S
UPPLY/RETURN
A
IR COVER
FIGURE 6
COVER GASKET DETAIL FOR UNITS SHIPPED FOR SIDE DISCHARGE
APPLICATION BEING CONVERTED TO DOWNFLOW
TAPE
A
ROUND FLANGE
SUPPLY/RETURN
AIR COVER
I
654
FIGURE 7
DUCT COVER INSTALLATION SIDE MOUNTING
I264
RETURN
DUCT COVER
(ATTACH WITH 6 SCREWS)
SUPPLY
DUCT COVER
(ATTACH WITH 6 SCREWS)
I
FIGURE 8
DUCT COVER INSTALLATION BASE PAN MOUNTING
I265
BASE PAN
SUPPLY DUCT
COVER
*
(INSULATION
SIDE UP),
ATTACH WITH
TWO SCREWS.
RETURN
DUCT
COVER
(INSULATION
SIDE UP,
ATTACH
WITH 4
SCREWS)
SUPPLY DUCT
COVER
*ROTATE SUPPLY COVER 90° AFTER IT IS INSERTED
THROUGH OPENING. SLIP FLANGE OF COVER
UNDER LANCE AT BACK OF BOTTOM SUPPLY DUCT
OPENING. SEE DETAIL AT LEFT. THEN SECURE
COVER BY INSTALLING 2 SCREWS USING HOLE
NEAREST THE OUTSIDE OF UNIT.
LANCE AT BACK OF BOTTOM
SUPPLY DUCT OPENING
FIGURE 8
C
OVER GASKET DETAIL FOR UNITS SHIPPED FOR DOWNFLOW
A
PPLICATION BEING CONVERTED TO SIDE DISCHARGE
FIGURE 9
COVER GASKET DETAIL FOR UNITS SHIPPED FOR SIDE DISCHARGE
APPLICATION BEING CONVERTED TO DOWNFLOW
FIGURE 10
DUCT COVER INSTALLATION SIDE MOUNTING
FIGURE 11
DUCT COVER INSTALLATION BASE PAN MOUNTING