21
Maintenance and Care
Removing and reinstalling bottom plate
CAUTION: Disconnect the vacuum cleaner
from the electrical outlet before removing the
bottom plate.
• Depress handle release pedal twice and
place the vacuum cleaner in the low
position.
• Turn vacuum cleaner over, exposing the
underside.
• Slide locking latch to the right.
• Press tabs inward on each side and pull
bottom plate off.
• Reinstall by placing lower edge of bottom
plate along lower edge of nozzle. Snap
plate into place. Slide locking latch to the
left to secure.
NOTE: To ensure maximum cleaning
efficiency, the condition of the belt should
be checked regularly. If belt is stretched,
cracked or if excessive slipping is
occurring, replace the belt.
To Next Page