1280 Enterprise Series
Dual A/D Scale Card Installation
The Dual A/D Scale Card (PN 164683) provides two additional scale channels. The 1280 can support up to eight scales. The
configuration of each scale is stored both on the card and in the indicators memory. The CPU board will rewrite the calibration
to the A/D scale card if replacing or swapping installed cards.
Manuals can be viewed and downloaded from the Rice Lake Weighing Systems website at www.ricelake.com
Warranty information can be found on the website at
www.ricelake.com/warranties
Figure 1. Dual A/D Scale Card Kit
Table 1 Dual A/D Scale Card Kit Parts List
The included parts kit contains items used for installation of the card. Items listed for stud grounding of the shields pertain to the
panel mount enclosure. See the 1280 technical manual for more information on grounding the shield with the cord grip.
Table 2 Parts Kit (PN 163784)
Item No. Part No. Description Qty
1
160760 Board Assy, Dual A/D
1
2
14822 Screw, Mach 4-40 NCx1/4
1
3
164676 Face Plate, Option Card
1
4
167194 Label, Dual Scale A/D
1
Part No. Description Qty
14621 Nut, Kep 6-32NC HEX (used for stud grounding)
2
14822 Screw, Mach 4-40 NCx1/4 (secures card to controller assembly)
1
15130 Washer, Lock NO 6 Type A (used for stud grounding)
2
153883 Connector,5 Pos Screw Terminal (interface connector)
2
15631 Cable Tie, 3 inch Nylon (secures cable in panel mount installation)
4
53075 Clamp, Ground Cable Shield (used for stud grounding)
2
94422 Label, Capacity .40 X 5.00 (used with Dual Scale A/D scales)
2
166957
NTEP seal for the A/D card to prevent removal.
158208 - Screw, Mach 4-40 x 3/8 (2)
165927 - Clip, Load Cell Locking (1).
1
171801 Ferrite Core, Snap on (clips onto the load cell cable.)
2
January 19, 2018 PN 164653 Rev D
To Next Page
Need help?
General
