Richter RR20 - Alarm and Sleep Settings; Alarm Settings

PORTABLE DIGITAL RADIO
10
9. Alarm Settings
Note: Alarm functions will not work on battery power, the Radio must be
connected to USB power source for Alarms to function.
The Portable RR20 radio has 2 alarm functions for 2 different alarm
settings (Alarm 1 and Alarm 2) Once an alarm is activated you will nd
the alarm icon in the display.
Alarm setup
• Press and hold the
button to switch the radio on, then quick press
the MENU/SCAN button and then rotate the volume dial until you see
“SYSTEM” in the display and then press the dial to select, rotate the
dial until you see “Alarms” in the display and press the dial to select.
• Rotate the dial to select “Alarm1” or “Alarm2” and press the dial to
conrm.
• Rotate the dial to select “Time” and press the dial to conrm. Rotate
the dial to adjust the hours and press the dial to conrm, rotate the dial
to adjust the minutes and press the dial to conrm.
• Rotate the dial to select “Days” and press to conrm, rotate the dial to
select: Daily, Once, Weekdays or Weekends and press to conrm
• Rotate the dial to select “Mode” and press to conrm, rotate the dial to
select: DAB, FM or Buzzer and press to conrm.
• Rotate the dial to select “Volume” and rotate the dial to select the
alarm wake up volume and press the dial to conrm.
• Rotate the dial to select “Last Listened” or “Preset” to select a preset
station and press the dial to conrm.
• Rotate the dial to “Save” and press the dial to save the alarm setting
“Alarm1” will be displayed along with the alarm status “Off or On”
press the dial to access alarm status and press again to change the
alarm status by rotating the dial to select “On or Off” and press to
conrm.
• To check the alarm detail and status press and hold the
DIMMER/ALARM button until you see “Alarm1” in the display, rotating
the dial will step through the saved alarm settings when the radio is
switched on.