What to do If Something Goes Wrong
98
3
x
Clearing Misfeeds
CAUTION:
Important
❒
When clearing misfeeds, do not turn off the power switch. If you do, your
copy settings are cleared.
❒
To prevent misfeeds, do not leave any torn scraps of paper within the ma-
chine.
❒
If paper misfeeds occur repeatedly, contact your service representative.
Note
❒
More than one misfed areas may be indicated. In this case, check every appli-
cable area. Refer to the following charts: A, B, C, D, R, P, Y, Z
❒
You can find a sticker explaining how to remove misfed paper inside of the
front cover, upper side of the finisher.
❒
When the machine instructs you to reset originals, reset your originals to the
feeding position. The display will indicate the number of originals you
should return.
•
The fusing section of this equipment might be very hot. You should be very
careful that you don't touch this section when removing the misfed paper.
To Next Page
Loading...
