❍ If paper is already loaded, remove it from the paper tray, fan it well, and tap it on a flat surface such as a desk to even the edges.
Check that the position of the paper guides and the front end guide match the paper size.
❍ Beforehand, make sure to squeeze the front end paper guide, and then expand the guide.
4. Load paper with the print side face down but not over the limit mark.
5. Squeeze the front end paper guide, and then slide it to meet the edge of the paper.
6. Push tray 1 gently in until it stops.
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/acc/t0010.htm (2 of 3)2005/10/05 12:08:34
To Next Page
Loading...
