Product Support Guide
Model D117/D118
Ver.1.1 Page 12 of 48 6/21/2012
Subject to change without notice
Options
Unique/Common
U: Unique for this model
C: Common with listed model
Paper Feed Unit: D573
Part Number Description
Q’ty
/Unit
Expected Yield
Unique or
Common
AF031063 Feed Roller 1
120K C
D5732908 Friction Pad 1
120K U
PM / Yield Parts Yields
PM parts as well as yield parts are affected by the number of prints per job (P/J). The actual part life is
determined by the number of its rotations, which depends on the P/J. The number of rotations a part makes
per page increases, if the P/J is lower. This is because the machine always stops at a certain (fixed) time
after the last sheet is fed out, regardless of the P/J. The lower the P/J, the more revolutions are made per
page.
The table below shows the expected number of prints made for 1 P/J vs. 4 P/J.
Unit
Number of Prints (K copies/prints)
1 P/J 2 P/J 3 P/J 4 P/J
Black PCDU 40K 60K 60K 60K
Color PCDU 15K 24K 24K 24K
Image Transfer Belt
Cleaning Unit
81K 120K 120K 120K
Paper Transfer
Roller Unit
81K 120K 120K 120K
Fusing Unit 70K 120K 120K 120K
The expected yield of all PM & Yield parts is calculated assuming the following conditions:
• A4 (LT) short-edge feed
• Color ratio: 20%
• Expected ACV: 2k
To Next Page
Loading...
