Tray Paper Settings
41
2
Tray Paper Settings
This section describes the user tools in the Tray Paper Settings menu under Sys-
tem Settings.
Default settings are shown in bold type.
Important
❒ If the specified paper size differs from the actual size of the paper loaded in
the paper tray, a misfeed might occur because the correct paper size was not
detected.
❖ Paper Tray Priority: Copier (copier/Document Server)
Specify the tray to supply paper for output.
The default setting is Tray 1.
When optional cut paper tray is installed, the default setting will be the cut
paper tray.
When optional paper roll tray or optional cut paper tray is installed, [Tray 2]
is displayed.
When optional two paper rolls tray and cut paper tray are installed, [Tray 3] is
displayed.
❖ Paper Tray Priority: Printer
Specify the tray to supply paper for output.
The default setting is Tray 1.
When optional paper roll tray or optional cut paper tray is installed, [Tray 2]
is displayed.
When optional two paper rolls tray and cut paper tray are installed, [Tray 3] is
displayed.
To Next Page
Loading...
