Copier / Document Server Features
78
3
Reproduction Ratio
This section describes the user tools in the Reproduction Ratio menu under
Copier / Document Server Features.
Default settings are shown in bold type.
For details about the relationships between fixed reduce/enlarge ratios, docu-
ment sizes, and paper sizes, see "Supplementary Information", Copier / Docu-
ment Server Reference.
❖ User Reduce/Enlarge Ratio
You can register up to three frequently used Reduce / Enlarge ratios other
than the fixed Reduce / Enlarge ratio and have them shown on the initial dis-
play. You can also change registered Reduce / Enlarge ratios.
When you select [User Reduce/Enlarge Ratio], the ratio can be set from 25.0 to
400.0%, using the number keys.
•Metric version:
The default setting for "F1" is 70.7%.
The default setting for "F2" is 141.4%.
The default setting for "F3" is 200.0%.
• Inch Version (Engineering):
The default setting for "F1" is 64.7%.
The default setting for "F2" is 129.4%.
The default setting for "F3" is 200.0%.
• Inch Version (Architecture)
The default setting for "F1" is 66.7%.
The default setting for "F2" is 133.3%.
The default setting for "F3" is 200.0%.
To Next Page
Loading...
