Ricoh B234 - Page 40

SERVICE CALL CONDITIONS
B234/B235/B236/D101/D102/D103 4-38 SM
Staple Junction Gate Motor Error: 3K Finisher B830
SC735 B
The staple tray junction gate HP
sensor did not detect the gate at
the home position within 200 ms
after two attempts.
-or-
The HP sensor twice detected
the gate at the home position for
more than 200 ms after it was
supposed to open.
• Junction gate did not arrive at the home
position within the specified time
• Junction gate did not leave the home
position within the specified time
Pre-Stack Junction Gate Motor Error: 3K Finisher B830
SC736 D
The pre-stack junction gate HP
sensor did not detect the gate at
the home position for within 200
ms after two attempts.
-or-
The HP sensor twice detected
the gate at the home position for
more than 200 ms after it was
supposed to open.
• Junction gate did not arrive at the home
position within the specified time
• Junction gate did not leave the home
position within the specified time
Pre-Stack Transport Motor Error: 3K Finisher B830
SC737 D
The pre-stack transport motor is
not operating.
• Motor harness loose, broken, defective
• Motor is blocked by an obstruction
• Motor defective
• Finisher main control board defective
Pre-Stack Junction Gate Release Motor Error: 3K Finisher B830
SC738 D
The pre-stack junction gate
release HP sensor did not detect
the gate at the home position
within 200 ms after two attempts.
-or-
The HP sensor twice detected the
gate at the home position for more
than 200 ms after it was supposed
to open.
• Junction gate did not arrive at the home
position within the specified time
• Junction gate did not leave the home
position within the specified time