EasyManua.ls Logo

Ricoh B234 - Page 52

Ricoh B234
119 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERVICE CALL CONDITIONS
B234/B235/B236/D101/D102/D103 4-50 SM
Pre-bind jogger shutter error 792-13 D
Not detected at HP after the time
prescribed to arrive at the HP had
elapsed (more than 400 ms) (1st
detection, jam, 2nd detection, SC
error)
-or-
Detected at HP after the time
prescribed to leave the HP had
elapsed (more than 400 ms) (1st
detection, jam, 2nd detection, SC
error)
Shutter motor (M608) connector
loose, broken, defective
Motor overload
Motor defective
Shutter HP sensor (S605) connector
loose, broken, defective
Sensor defective
50/100 clamp adjustment error
792-14 D
Not detected at HP after the time
prescribed to arrive at the HP had
elapsed (more than 400 ms) (1st
detection, jam, 2nd detection, SC
error)
-or-
Detected at HP after the time
prescribed to leave the HP had
elapsed (more than 400 ms) (1st
detection, jam, 2nd detection, SC
error)
50/100 adjustment motor (M702)
connector loose, broken, defective
Motor overload
Motor defective
Ring switch HP sensor (S706)
connector loose, broken, defective, or
sensor defective
Ring switch timing sensor (S707)
connector loose, broken, defective, or
sensor defective
Timing sensor interval error 792-15 D
The bind timing sensor (S702)
remained ON or OFF longer than
the prescribed time (1500 ms)
during initialization or ring binding
(1st detection: jam, 2nd detection:
SC error)
Clamp unit motor (M701) connector
loose, broken, defective
Motor overload
Motor defective
Bind timing sensor (S702) connector
loose, broken, defective
Sensor defective
Clamp unit HP error 792-16 D
At initialization or during ring binding,
did not arrive at the home position
within the prescribed time (1500 ms)
(1st detection: jam, 2nd detection: SC
error)
-or-
Detected at HP after the time
prescribed to leave the HP had
elapsed (more than 1500 ms) (1st
detection, jam, 2nd detection, SC
error)
Clamp unit motor (M701) connector
loose, broken, defective
Motor overload
Motor defective
Clamp unit HP sensor (S701)
connector loose, broken, defective
Sensor defective

Other manuals for Ricoh B234

Related product manuals