Ricoh B234 - Page 72

SERVICE CALL CONDITIONS
B234/B235/B236/D101/D102/D103 4-70 SM
Switchback Flapper HP Sensor (S10) Error
SC796-13 A
The switchback flapper HP sensor in the
stacking tray did not go ON after the motor
turned on long enough to raise the flapper
through an arc of 50 degrees.
-or-
The switchback flapper HP sensor did not go
OFF after the motor remained on long
enough to lower the flapper through an arc of
150 degrees.
• Switchback flapper HP
sensor (S10) defective
• Switchback flapper
motor (M8) defective
• Sensor or motor
connector loose, broken,
defective
TE Press Lever HP Sensor (S3) Error
SC796-14 A
The TE press lever HP sensor in the stacking
tray did not go ON the TE press lever motor
remained on long enough to move the lever
through and arc of 30 degrees to release the
lever.
-or-
The TE press lever HP sensor did not go
OFF when the TE press lever motor
remained on long enough to move the lever
through and arc of 20 degrees to close the
lever.
• TE press lever HP
sensor (S3) defective
• TE press lever motor
(M3) defective
• Sensor or motor
connector loose, broken,
defective
Jog Fence HP Sensor: Front/Small (S12) Error
SC796-15 A
The front jog fence HP sensor in the stacking
tray for small size paper did not go ON within
the prescribed time after the front jogger motor
turned on long enough to move the fence front
jog fence.
-or-
The front jog fence HP sensor for small size
paper did not go OFF within the prescribed
time after the front jogger motor turned on to
move the front fence.
• Jog fence HP sensor:
front/small (S12)
defective
• Jogger motor: front
(M4) defective
• Sensor or motor
connector loose,
broken, defective
Jog Fence HP Sensor: Front/Large (S14) Error
SC796-16 A
The front jog fence HP sensor for large size
paper in the stacking tray did not go ON within
the prescribed time after the front jogger motor
turned on to move the front fence.
-or-
The front jog fence HP sensor for large size
paper in the stacking tray did not go OFF within
the prescribed time after the front jogger motor
turned on to move the front fence.
• Jog fence HP sensor:
front/large (S14)
defective
• Jogger motor: front
(M4) defective
• Sensor or motor
connector loose,
broken, defective