Ricoh B234 - Page 82

SERVICE CALL CONDITIONS
B234/B235/B236/D101/D102/D103 4-80 SM
Signature Exit Path Press Sensor (S68) Error
SC796-55 A
The signature exit path press sensor did not
go ON within the prescribed time after the
signature exit path motor turned on to feed
the book into the nip of the signature exit
roller.
-or-
The signature exit path press sensor did not
go OFF within the prescribed time after the
signature exit path motor turned on to
retract the signature exit roller.
• Signature Exit Path Motor
(M30) defective
• Signature Exit Path Press
Sensor (S68) defective
• Motor or sensor connector
loose, broken, defective
Signature Exit Roller Error
SC796-56 A
The leading edge sensor did not go ON
within the time prescribed for the
signature exit roller to reverse feed the
signature during signature exit.
• Signature Roller Exit Motor
(M27) defective
• Leading Edge Sensor (S65)
defective
• Signature torn, bent
Inserter EEPROM Error
SC796-57 A
CHECKSUM error at power on.
-or-
EEPROM write error.
• EEPROM not installed, or not
installed correctly
• EEPROM defective
Inserter Drive Switch Sensor (S16) Error
SC796-58 A
The drive switch sensor in the inserter
did not go OFF within the time
prescribed after the drive switch motor
(M2) turned on.
-or-
The drive switch sensor in the inserter
did not go ON within the time
prescribed after the drive switching
motor (M2) turned on.
• Drive switch motor (M2)
defective
• Drive switch sensor (S16)
defective
• Motor or sensor connector
loose, broken, defective
• Connector loose, broken,
defective
Inserter Tray A Error
SC796-59 A
Inserter Tray A (upper tray)
failed to leave its lower limit
sensor within the prescribed
time after Tray A lift motor
turned on.
• Lift Motor: Tray A (M3) defective
• Lower Limit Sensor: Tray A (S11)
defective
• Motor or sensor connector loose,
broken, defective
Inserter Tray A (upper tray)
failed to arrive at its paper feed
sensor within the prescribed
time after the Tray A lift motor
turned on.
• Lift Motor: Tray A (M3) defective
• Paper Feed Sensor: Tray A (S4)
defective
• Motor or sensor connector loose,
broken, defective