SERVICE CALL CONDITIONS
SM 4-81 B234/B235/B236/D101/D102/D103
Trouble-
shooting
Inserter Tray B Error
Inserter Tray B (lower tray)
failed to leave its lower limit
sensor within the prescribed
time after the Tray B lift
motor turned on.
• Lift Motor: Tray B (M4) defective
• Lower Limit Sensor: Tray B (S12)
defective
• Motor or sensor connector loose, broken,
defective
SC796-60 A
Inserter Tray B (lower tray)
failed to arrive at its paper
feed sensor within the
prescribed time after the
Tray B lift motor turned on.
• Lift Motor: Tray B (M4) defective
• Paper Feed Sensor: Tray B (S10)
defective
• Motor or sensor connector loose, broken,
defective
Relay Unit EEPROM Error
SC796-61 A
EEPROM write error (successful
completion of data write operation not
detected within the prescribed time).
• Relay board EEPROM not
installed, or installed incorrectly
• EEPROM damaged
• Relay board defective
Relay<-> Bookbinder Communication Error
SC796-62 A
Communication error
between relay unit and
bookbinder.
• Relay I/F cable disconnected or damaged
• Relay unit PCB in bookbinder damaged, not
installed correctly
• PCB in relay unit damaged, not installed
correctly
Lower Performance Mode Error
These are the conditions that must be met before the bookbinder enters low
performance mode:
1. The location where the error occurred has no effect on the operation
of the horizontal feed path for downstream delivery.
2. The jam has occurred in the horizontal feed path but it can be
removed easily.
3. The unit where the error occurred allows use of the horizontal feed
path.
4. These conditions determine whether downstream delivery is
possible after an error occurs in the bookbinder.
SC796-63 D
Correct the problem and release the bookbinder from the low performance
mode. See Section 3 of the Perfect Binder manual for more about how to
release the Perfect Binder from the lower performance mode.
To Next Page
Loading...
