Ricoh B234 - Page 84

SERVICE CALL CONDITIONS
B234/B235/B236/D101/D102/D103 4-82 SM
Important: The SC797-** series SC codes apply to the Perfect Binder
D391.
Grip HP Sensor (S93) Error
SC797-1 B
The grip HP sensor did not go OFF within
the prescribed time because the main grip
did not leave its home position.
-or-
The main grip unit did go ON because it did
not arrive at the HP position after signature
release.
• Book grip motor (M43)
defective
• Grip HP sensor (S93)
defective
• Sensor or motor harness
loose, broken, defective
Grip End Sensor (S94) Error
The grip end sensor (S94) did not go
OFF after the grip unit released the
signature and moved the prescribed
distance.
• Book grip motor (M43) defective
• grip end sensor (S94) defective
• Sensor or motor harness loose,
broken, defective
SC797-2 B
The grip end sensor (S94) did not go
ON because the grip unit did arrive at
the sensor position.
• Book grip motor (M43) defective
• grip end sensor (S94) defective
• Sensor or motor harness loose,
broken, defective
• Data received for signature data
was incorrect.
Trimmings Buffer HP Sensor: Left (S103) Error
SC797-3 B
The trimmings buffer sensor: left (S103)
did not go OFF within the prescribed
time because it failed to leave the HP
sensor.
-or-
The trimmings buffer sensor: left (S103)
did not go ON within the prescribed time
because it failed to arrive at the HP
sensor.
• Trimmed scraps in or around
the trimmings buffer
• Trimmings buffer motor (M37)
defective
• Left trimmings buffer sensor
(S103) defective
• Sensor or motor harness
loose, broken, defective
Trimmings Buffer HP Sensor: Right (S100) Error
SC797-4 B
Trimmings buffer did not reach the
trimmings dump port because:
The trimmings buffer sensor: right
(S100) did not go OFF within the
prescribed time because it failed to leave
the HP sensor.
-or-
The trimmings buffer sensor: right
(S103) did not go ON within the
prescribed time because it failed to
arrive at the HP sensor.
• Trimmed scraps in or around
the trimmings buffer
• Trimmings buffer motor (M37)
defective
• Right trimmings buffer sensor
(S100) defective
• Sensor or motor harness
loose, broken, defective
Trimmings Buffer Motor (M37) Error
SC797-5 B
Trimmings buffer motor
(M37) is not running.
• Trimming scrap jam
• Trimmings buffer motor (M37) defective
• Right or left trimmings buffer sensor (S100,
S103) defective
• Motor or sensor connections loose, broken,
defective