Ricoh CX5 - Using the Self-Timer

37
If you are using the camera for the first time, read this section.
Using the Self-timer
You can set the self-timer to shoot after either two or ten seconds, or
you can select [Custom Self-Timer] (GP.83) to customize the self-
timer setting.
1
With the camera ready to shoot, press the t (Self-timer)
button.
• A list of self-timer mode settings appears on the picture display.
2
Push the ADJ./OK button !" to
select the mode.
• The self-timer symbol and the
number of seconds are displayed at
the upper left of the picture display.
ĵĻ
ĵĻĴ ŇĵĻĴŇ
ĵĻĴ Ň
3
Press the shutter release button.
• When set to [10], the self-timer lamp lights for 8 seconds when the
self-timer starts and then blinks for the final 2 seconds before the
picture is taken.
• When set to [Custom Self-Timer], the self-timer lamp blinks for 2
seconds before each picture is taken, and pictures are taken at the
set shooting interval. The focus position is set for the first shot.
• When set to [Custom Self-Timer], press the MENU button to cancel
the self-timer during shooting.
Note -------------------------------------------------------------------------------------
• The camera remains in self-timer mode even after the image is shot. To cancel the
self-timer, press the t button and change the self-timer setting to [Self-Timer Off].
• When the self-timer is set to 2 seconds, the self-timer lamp does not light or blink.
• When the self-timer is set, the [Interval Shooting] setting is disabled.