100
Procedure 2: Disabling the decurl setting and delivering sheets with their
printed side facing down
Note:
• Apply this procedure only when all of the following conditions are met.
• The decurler unit is attached.
• A back-curl is required to flatten curls.
• Sheets are delivered with their printed side facing up in the post-processing
machine.
1.
In the [Adjustment Settings for Skilled Operators] menu, check the present
degree of decurling (Off, Weak, or Strong) in [0116: Adjust Paper Curl].
2.
Is it "Adjust Curl: Weak" or "Adjust Curl: Strong"?
Yes
Go to the next step.
No
Contact your service representative.
3.
Is this setting essential?
Yes
Go to the next step.
No
Set [0116: Adjust Paper Curl] to "Adjust Curl: Off" (set it back to the
default value).
4.
Are the sheets delivered with their printed side facing up.
Yes
Go to the next step.
No
Contact your service representative.
5.
Is this setting essential?
Yes
Contact your service representative.
No
Change the setting so that the sheets are delivered with their printed
side facing down.
6.
Print the image. Is the problem resolved?
Yes
Finished!
No
Contact your service representative.
To Next Page
Loading...
Need help?
General
