108
<If scratches, streaks, or creases appear on the side 1 of the paper>
You can lessen the problem by increasing the paper feed speed of the decurler unit.
1.
In the [Adjustment Settings for Skilled Operators] menu, check the present
degree of decurling (Off, Weak, or Strong) in [0116: Adjust Paper Curl].
2.
In [Advanced Settings] for the custom paper in use, adjust the paper feed
speed of the decurler unit.
• If the degree of decurling is set to "Off", increase the value in [51: Decurler
Feed Speed Adj: Curl Adj Off] by 0.5%.
• If the degree of decurling is set to "Weak", increase the value in [52:
Decurler Feed Speed Adj: Curl Adj Weak] by 0.5%.
• If the degree of decurling is set to "Strong", increase the value in [53:
Decurler Feed Speed Adj: Curl Adj Strg] by 0.5%.
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Keep increasing the value by 0.5 mm until the problem is resolved.
If the problem persists even though the value has reached its
maximum value, contact your service representative.
To Next Page
Loading...
Need help?
General
