31
a) Line splatter that is 5 mm (0.2 inches) or less from the leading edge
Increase the leading edge margin to more than 5 mm (0.2 inches) using one of the
following procedures:
(1) Adjusting the shift image
In [Advanced Settings] for the custom paper in use, specify [08: Adj Image
Position of Side1 With Feed] for the side 1 of the paper and [09: Adj Image
Position of Side2 With Feed] for the side 2.
(2) Adjusting the mask width at the leading edge
In [Advanced Settings] for the custom paper in use, specify [13: Adjust Erase
Margin of Leading Edge].
(3) Adjusting the file's leading edge margin
Increase the leading edge margin in the print settings for the image to be
printed.
For details about adjusting the shift image and adjusting the mask width at the
leading edge, see "Adjustment Item Menu Guide".
If you cannot increase the leading edge margin to more than 5 mm (0.2 inches),
contact your service representative.
b) Line splatter that is in an area more than 5 mm (0.2 inches) from the
leading edge
1.
Configure the following settings in [Advanced Settings] for the custom paper
in use.
<Printing in black and white>
Increase the absolute value of the current by 10 μA in [26: Image Transfer
Current: B&W].
<Printing in full color>
Increase the absolute value of the current by 10 μA in [27: Image Transfer
Current: FC: Black].
2.
Print the image. Is the problem resolved?
Yes
Finished!
No
Increase the value by 10 μA.
3.
Repeat Step 2. If the problem persists even though you have set the current
to 70 μA (maximum), contact your service representative.
To Next Page
Loading...
Need help?
General
