Ricoh D074 Series Troubleshooting

33
Solution:
<Printing in full color>
1.
In [Advanced Settings] for the custom paper in use, select [27: Image
Transfer Current: FC: Black].
2.
Check the present value. Is it lower than 50 μA ?
Yes
Carry out all of the following:
(1) Increase the value by 5 μA in [27: Image Transfer Current: FC:
Black].
(2) Set [40: Paper Transfer Current; Trail Edge: FC] to "200%".
(3) Set [42: Ppr Transfer Current Trail Edg Dist: FC] to "30 mm".
No
No further improvement is likely. Contact your service representative.
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Repeat Steps 1 to 3. If the problem persists even though you have
increased the value to 50 μA, contact your service representative.
<Printing in black and white>
1.
In [Advanced Settings] for the custom paper in use, select [26: Image
Transfer Current: B&W].
2.
Check the present value. Is it lower than 50 μA ?
Yes
Carry out all of the following:
(1) Increase the value by 5 μA in [26: Image Transfer Current: B&W].
(2) Set [39: Paper Transfer Current; Trail Edge: B&W] to "200%".
(3) Set [41: Ppr Transfer Current Trail Edg Dist: BW] to "30 mm".
No
No further improvement is likely. Contact your service representative.
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Repeat Steps 1 to 3. If the problem persists even though you have
increased the value to 50 μA, contact your service representative.

Ricoh D074 Series Specifications

General

Brand	Ricoh
Model	D074 Series
Category	Printer
Language	English