48
Solution:
1.
Make a note of the present value in the following setting in [Advanced
Settings] for the custom paper in use.
<Printing in black and white>
[35: Paper Transfer Current; Lead Edge: B&W]
<Printing in full color>
[36: Paper Transfer Current; Lead Edge: FC]
2.
Increase the scaling factor in the above setting by 10 percentage points.
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Increase the scaling factor by 10 percentage points.
4.
Repeat Step 3. If the problem persists even though you have increased the
scaling factor by 50 percentage points, restore the value noted in Step 1 and
go to the next step.
5.
Decrease the scaling factor in the above setting by 10 percentage points.
6.
Print the image. Is the problem resolved?
Yes
Finished!
No
Decrease the scaling factor by 10 percentage points.
7.
Repeat Step 6. If the problem persists even though you have decreased the
scaling factor by 50 percentage points, restore the value noted in Step 1 and
contact your service representative.
To Next Page
Loading...
Need help?
General
